Shaanxi Nick Machinery Equipment Co. LTD
TEL:86-29-86031588
Fax:86-29-86031588 Sitemap
Add:East Qunsheng Road Wuxi City,Jiangsu,China
Email:sales@nkbaler.com
WhatsApp:008615021631102
How to clean the hyd Your current location:Home >> How to clean the hyd
How to clean the hydraulic system of the baler
Author : admin Time : 2021-01-08 AllPageView : 107
How to clean the hydraulic system of the baler The baler mainly packs waste products such as waste paper, so the baler must be cleaned in the field to avoid failure of the baler and affect work efficiency.

Method of cleaning the hydraulic system of a baler

1. String the baling press rope of the hydraulic baler through the automatic elastic device behind the garbage compressor, and place it along the baling press belt groove, then tie the baling press belt to the bottom end of the baling press groove, and rotate the automatic elastic device 90 degrees , Close the bottom door and lock it
2. Put the recycled waste paper, plastic, and film garbage into the hydraulic baler. When the material is loaded to the height of the pressure plate, close the door and press the "press down" button. The equipment runs automatically and is compacted. (The feeding height of materials other than cardboard can only be slightly higher than the bottom door)

3. The pressure plate moves down and compresses to reach the maximum pressure, and it automatically returns to the fully open position. When compressing and baling press constraints, the pressure plate stops at the preset position of the compressed material

4. Open the door of the device and put the tie rope through the bottom slot from front to back and return to the front through the pressure plate slot, then pull the tie rope tightly and knot it by hand. Push the baling press rod by hand, push the rod to a fixed position, and tighten it. Press the "up" button, the return stroke of the cylinder will automatically turn out the bundled bales. (It is not allowed to stand in front of the door when opening the door to avoid accidental injury by the door bounce)

5. After the bale is ejected, reset the bale lever to press down. Finally, remove the bundled waste paper and plastic garbage before stacking and storing, close and lock the door to enter the next packaging cycle.
The above are the points summarized by Nick Machinery through more than ten years of experience. If you still don’t understand, you can call our after-sales telephone to consult 86-29-86031588, www.nkbaler.com.
Shaanxi Nick Machinery Equipment Co. LTD
TEL:86-29-86031588
Fax:86-29-86031588 Sitemap
Add:East Qunsheng Road Wuxi City,Jiangsu,China
Email:sales@nkbaler.com
WhatsApp:008615021631102
Copyright © 2018 NKBALER .rights reserved
Whats App Skype Shaanxi Nick Machinery
Equipment Co. LTD