Today,I will talk about the issues that you should pay attention to when adjusting pressure:
1.It is not allowed to adjust the working pressure of the system when the actuator is in motion.
2.Before adjusting the pressure,check whether the pressure gauge of the hydraulic baler
is abnormal.If there is any abnormality,adjust the pressure after the pressure gauge is replaced.No pressure gauge system is not allowed to adjust pressure.
3.In the process of pressure adjustment,there may be no pressure in the system of the hydraulic baler or the pressure rise cannot reach the adjusted value.At this time,the pump should be stopped and checked carefully,and the adjustment should be continued after troubleshooting.The reason must be rigid adjustment.
4.The size of the pressure adjustment is adjusted according to the design requirements or the pressure value required by the actual use,and should not exceed the specified pressure value.
5.After pressure adjustment,the adjustment screw should be locked to prevent loosening.
When adjusting the pressure of the hydraulic metal baler
during operation,pay close attention to the operating state of the hydraulic pump during this process,whether there is abnormal noise or vibration,and check whether all parts leak after the pressure rises.Turn off the motor immediately and proceed.
After the pressure adjustment is completed,the actuators of the hydraulic baler
should move quickly in the full stroke,the gas accumulated in the system can be eliminated,and the performance of reversing and switching can be judged.The smoothness of the movement can be observed when moving at low speed.Check whether the actions of the hydraulic baler
's actuators conform to the designed sequence and whether the actions are coordinated.