How to use scrap metal baler,I think many people are not very familiar with it,I would like to introduce it to you.
1.Before starting the scrap metal baler,check whether the appearance of the equipment is abnormal,whether there are safety hazards around,and whether the iron wire or plastic rope is enough.After confirming that it is normal,turn on the main control switch of the distribution box,release the pop-up emergency stop button,and the power indicator light of the electric control box is on.
2.Turn the remote local gear selection switch to the remote control gear.
3.Put the magnetic switch on the remote control into the card slot,press the system start button on the remote control twice,stop the preparation operation of the warning equipment after the siren rings for 10 seconds,and the red alarm light is always on.
4.Press the start button of the conveyor belt on the remote control to run the conveyor belt,push the paper sheet or other materials into the material port,and the conveyor belt will bring the material into the packing inlet.
5.After the paper or other materials arrive at the position,press the remote control on the tightening button,the red alarm light flashes, and the active retreat stops after the indenter is pressed in place.
6.Repeat operation 4 until the required packing length is reached,press and hold the bundling button on the remote control for 2 seconds,and then the equipment will start up actively.When the pressure head advances to the front baling position,it will stop and the siren will give an alarm at a frequency of 3 seconds after it is in place.
7.Press the threading button on the remote control,and the threading machine will take the initiative to return to the original position after threading the iron wire or plastic rope.
8.Tie the iron wire or rope and cut it.One package is finished.
9.Repeat the above 4-8 procedures.The bags at the outlet will be pushed out one by one,and the product packages will be moved to the appropriate address with holding vehicle or forklift truck,and placed in a regular manner.
10.After the operation is completed,press the remote control system stop button,take down the magnetic switch,press the emergency stop switch of the electric cabinet,and close the main power supply.
The above are the 10 basic processes of scrap metal baling machine operation,and its operation process is not very difficult.You only need to carefully operate several times to gradually understand it,but you must pay attention to safety in the operation process. Nick metal baler is easy to operate, safe and energy-saving, is your best helper