5. Clean the soil inside the straw silage baler equipment, dry the coils, check the insulation and electrical conductivity, remove the soil on the battery pole posts, apply butter on the line cards and pole posts, and unscrew the filling hole cap , Unblock the vents, clean the impurities in the battery with distilled water, and add electrolyte to charge after washing.
If the straw silage baler works in the wheat field for a long time, there will be a lot of weeds or straw husks entering the fan of the equipment, which may cause short-term adverse effects, but you will not see it in the long-term. It will cause clogging of the straw silage baler, which will seriously affect the overall efficiency of the machine. What should be done?
5. When there is no alternative, the front cover of the straw silage baler can be temporarily removed, and the engine and cooling system are directly exposed to the air. This also has some heat dissipation effects, but it looks very unsightly. I generally wish Do not use it.
The use of straw silage baler for a long time will inevitably cause various problems, which will increase the maintenance rate of the equipment. Once the maintenance rate increases, the service life of the equipment will be reduced. Therefore, in order to extend its service life, we What needs to be done is to maintain the straw silage baler. Below, I will introduce the maintenance points of the relevant equipment. I hope you can read it carefully.
5. Clean the soil inside the straw silage baler equipment, dry the coils, check the insulation and electrical conductivity, remove the soil on the battery pole posts, apply butter on the line cards and pole posts, and unscrew the filling hole cap , Unblock the vents, clean the impurities in the battery with distilled water, and add electrolyte to charge after washing.
When the straw silage baler is used for a long time, it is inevitable that there will be some failures. The relatively high number of these failures is that the straw silage baler cannot work quickly. If you want to solve the failure, then we must first understand the straw silage The reason why the Baler cannot work quickly, I hope everyone can read it carefully.
1. The oil supply pressure of the oil pump of the straw silage baler cannot meet the flow demand. In order to avoid the occurrence of oil leakage, strict inspection and testing are required before operation.3. The internal and external oil leakage is relatively severe. In the fast operation, the oil supply pressure is too low, but the pressure is much higher than that of the oil return circuit. When the piston seal of the Baling Press machine cylinder is damaged, the two ends of the Baling Press machine cylinder are simply caused The accident of excessive internal leakage caused the rapid movement speed of the oil cylinder of the straw silage baler to fail, and other parts of the straw silage baler also leaked oil.
4. A series of reasons such as the lubrication of the guide rail and the poor installation accuracy and poor installation accuracy of the oil cylinder in the straw silage baler have caused the frictional resistance to increase during the operation of the baler.1. The actual voltage fluctuates too much and exceeds the rated voltage range. The general voltage deviation of the domestic paint wire is 5%, and the good manufacturer can reach 10%
There is a closed cavity in the solenoid valve with through holes at different positions. Each hole leads to the tubing of a different solenoid valve. In the middle of the cavity is the valve and two electromagnets on both sides. Which side of the magnet coil will energize the valve body Which side is attracted to, by controlling the movement of the valve body to block or leak different oil discharge holes, and the oil inlet hole is normally open, the hydraulic oil will enter the different oil discharge pipes, and then the oil cylinder will be pushed by the oil pressure The piston drives the piston rod, and the piston rod drives the mechanical device to move. In this way, the mechanical movement is controlled by controlling the current on and off of the electromagnet.